Open Source Projects

Tableau de Bord de TIM-07

PCB

Small PCB to handle PIN diodes to monitor the light attenuation of fibers during irradiations

24-channels HL_MEM to be able to read all PNs from a ECAL Super-Module. There are 2 tentative PCB : One to be located in the legacy MEM box outside SM and one to be located inside the SM at the place used by the Token-ring boards. Both have 24 LiTE-DTUs in test mode. Only other samples are read (80 MHZ sampling) and both MONACAL outputs are digitized and send to BE electronics through 2 FE boards.

FEM_v1 consists of 2 small PCB : - One to handle the PN diodes (FEM_v1_PN) and - one which support the MONACAL chip (FEM_v1_MONACAL). This should fit on the allowed place on the Super-Module front face between 2 fibers raws

Test board for MONACAL-v1 : - 1 MONACAL soldered for accurate tests and 1 MONACAL on test socket for fast production validation - 1 CATIA-v1.3 for Vinj generation - To be connected to ADC board used for CATIA irradiation tests (read by FEAD board) - Possibility for external charge injection - Possibility to insert long cable for MONACAL powering and signal return

2-channel HL_MEM to readout 1 FEM (2 PN diodes and one MONACAL) Use of LITE-DTU V1.2 in test mode to get only other samples To be plugged on a FEAD board

Almost same schematics as LiTE-DTU_calib, but with a test socket to be able to fast validate LiTE-DTU_v1.2 after production.

VFE-like board with 1 CATIA and 1 LiTE-DTU to test CATIA-LiTEDTU interface and also noise from DCDC converters. Use CATIA-V1 and LiTE-DTU-V1.2