Open Source Projects
Explore open source hardware projects other folks uploaded and share your own. With CADLAB.io hardware version control it is way easier to work on hardware design projects together.
Tableau de Bord de TIM-07
Small PCB to handle PIN diodes to monitor the light attenuation of fibers during irradiations
24-channels HL_MEM to be able to read all PNs from a ECAL Super-Module. There are 2 tentative PCB : One to be located in the legacy MEM box outside SM and one to be located inside the SM at the place used by the Token-ring boards. Both have 24 LiTE-DTUs in test mode. Only other samples are read (80 MHZ sampling) and both MONACAL outputs are digitized and send to BE electronics through 2 FE boards.
FEM_v1 consists of 2 small PCB : - One to handle the PN diodes (FEM_v1_PN) and - one which support the MONACAL chip (FEM_v1_MONACAL).
This should fit on the allowed place on the Super-Module front face between 2 fibers raws
Test board for MONACAL-v1 :
- 1 MONACAL soldered for accurate tests and 1 MONACAL on test socket for fast production validation
- 1 CATIA-v1.3 for Vinj generation
- To be connected to ADC board used for CATIA irradiation tests (read by FEAD board)
- Possibility for external charge injection
- Possibility to insert long cable for MONACAL powering and signal return
2-channel HL_MEM to readout 1 FEM (2 PN diodes and one MONACAL)
Use of LITE-DTU V1.2 in test mode to get only other samples
To be plugged on a FEAD board
Almost same schematics as LiTE-DTU_calib, but with a test socket to be able to fast validate LiTE-DTU_v1.2 after production.
VFE-like board with 1 CATIA and 1 LiTE-DTU to test CATIA-LiTEDTU interface and also noise from DCDC converters.
Use CATIA-V1 and LiTE-DTU-V1.2
