Files

copied
Last update 4 years 6 months by Mark Anderson
Files
gerberfiles
pictures
ESP8266-ESP12.lbr
README.md
XM1584.lbr
dirt_cheap_dirty_boards.v1.cam
dirt_cheap_dirty_boards.v1.dru
esp12_RGBWW.brd
esp12_RGBWW.sch
fhem.logo.lbr
README.md

ESP8266 WiFi RGBWW LED Dimmer v1.5

Custom Hardware board for controlling 5 Led Channels via PWM (RGB + Warm/Cold White). It is designed for max current ~4.5A per Channel.

Changelog

  • 1.5 (31.01.2017)

    • DCDC wandler has been remeasured and provided for through hole mounting on pin headers
    • Jumper introduced for allowing for external 3,3V connections
    • measurements have been changed to 53mm*47mm with mounting holes tailored towards "Strapubox CO 4" casing
    • C1 has been replaced with a smaller form factor
  • 1.3 (20.02.2016)

    • added another tact switch which can be used during boot to reset settings
    • silksceen naming updated
  • 1.2 (16.02.2016)

    • improved the layout for better EMV
    • added buffer capacitor for dc converter
    • added filter capacitor close to ESP8266
  • 1.1 (01.02.2016)

    • connected ADC
    • some layout improvements

Parts

  • 1x ESP8266, ESP-12 format
  • 1x XM1584 Power converter (set to 3.3v!)
  • 5x IRLZ44N Mosfet (logic level gate threshold)
  • 11x 10k resistors, 0805 (R1 - R11)
  • 1x 1k resistors, 0805 (R12)
  • 1x 330 µF Elko RM 2.5 mm (C1)
  • 1x 100 µF Elko RM 2.5 mm (C3)
  • 1x 100 nF capacitor 0805(C2)
  • 3x 5,08mm 2pin terminal block
  • 1x 5,08mm 3pin terminal block
  • 1x 2,54mm 4pin header
  • 2x Micro SMD Tact Switch 2 pin 362.5 mm (optional)

Assembly

Assembly of the PCB Board is straight forward, solder all parts to the PCB.

Caution : before soldering the esp module to the PCB, set the output voltage of XM1584 converter to 3.3v

Recommended steps

  • Start with soldering the smd resistors
  • Ensure the output voltage of XM1584 converter is 3.3v before continuing.
  • Solder the XM1584 Power Board
  • Solder ESP8266 Module
  • Optional: solder SMD Tact Switch
  • Solder Elkos
  • Solder Terminal Blocks, 4pin header
  • Solder FETs

Firmware

Firmware is still work in progress.

Latest can be found here: ]]>https://github.com/patrickjahns/esp_rgbww_controller_fw]]>

Modifying

The schematic and board files are compatible with eagle 7.2+

Ideas

Here are some ideas for future revisions - see if we can clear some GPIOs and provide them via PIN Header for other enhancements (i.e. IR / Rotary Controller) - change layout for VCC/GND to be on the left side - ~~connect ADC to detect power failure~~

Resources

Thread in Fhem Forum

Credits

Thanks to RiRomain for his excellent documentated ]]>ESP RGB Project]]>

Report a bug