README.md
View this project on CADLAB.io.

DS2482 Breakout

Eagle layout for a breakout board for the Maxim DS2482 I2C to 1-wire chip

 

This is a work in progress! I just sent the boards off to OSH Park for etching, so I haven't confirmed it actually works yet.

Components


1 x Maxim DS2482 Single-Channel 1-Wire Master
2 x 1.2k SMD resistors (Package: M0805 )


Pin out of connector (looking component side up, connector on the left)


Vcc - Nominally 5V. You can use 3.3V but the pull up resistors probably nned to be changed
1-wire - the 1-wire network wire
Ground.
The SCL pin on the I2C interface
The SDA pin on the I2C interface


Ardiuno Sample code

Coming soon...

References

<![CDATA[]]>https://www.maximintegrated.com/en/products/interface/controllers-expand...<![CDATA[]]>