Dennis Field / dvk-mx8m-bsb - History

Changes in the rough placement:
Swapped positions of M.2 and miniPCIE cards, as this results in less signal crossings under the SOM.
Moved some forgotten parts back to their respective groups.

Replace the CMC-6022-37T microphoen with the CMC-2242PBL-A THT one since the old one cannot be surface mounted/reflowed, add the microphone's 3D model

The microphone's pin position/order is agrees with the manufacturer's "measurement circuit" from the datasheet such that the right (facing the top of the mic) terminal/pin is its GND (-).

Update all of the 3D model paths to the new directory name structure, use the correct camera mating connector part number AXT530124 instead of AXT630124 which is the one found on the camera, add the camera connector's 3D model

Rotate the USB-C TCPC PHY 180 degrees after the SoM has been rotated

Rotated SOM by 180 degrees (mainly for shorter display connection)
Moved component groups closer to the center
Unrouted net lines are now shorter in general (density is unfortunately higher)

Routing of some componentents near Ethernet-PHY.
PHY-Chip is located near MagJack, eventually it must be moved away later.

Make use of changed footprint J1701 / MagJack in layout file.

Slightly reduced restring diameter of Molex Ethernet MagJack - makes it possible to connect traces on the top layer.

Move the vias near the new 0603 footprints to more proper locations, route the bypass/bulk caps on the VBUS_REG rail