Dennis Field / dvk-mx8m-bsb - History

Move the WLAN+BT M.2 sheet back to page 18 rather than the last page (24)

Make TVS diodes on USB-C's SBU1 & SBU2 NC since they're unused

Remove unneeded PWR_FLAG symbol due to the last commit's change

Move the ground connection on the USB-C receptacle from the shield pin to the GND pins (shield is still connected to GND via the 0 ohm resistor), make the cap between the receptacle's GND and shield NC

This commit is thanks to the feedback from our design reviewer

Add AC coupling caps to the HDMI_AUXP/N diff pair which were mistakenly left out, fix a couple typos/errors that were made when transitioning to the new top-leve sheet, make the M.2s' I2C RX TX hierarchical signals consistent and clearer

Hopefully all lingering errors have been caught, this will likely be the schematic commit that gets reviewed (fingers crossed).

Assign TLV3201AIDBVR footprint based on the SOT-23-5 official footprint using the given solder mask clearance and pad clearance parameters, assign the QFN48 3D model to the ETH PHY footprint, make some minor adjustments to the front sheet's layout

Reorder USB-C's diff pairs based on layout simplicity as done on EmCraft's Rev 2 baseboard (requires Lane Polarity Inversion), add 2 and 3-channel differential filter & TVS IC footprints (used with USB-C and HDMI), import USB-C receptacle 3D model

Used a scaled version BGA-256_16x16_17.0x17.0mm_Pitch1.0mm 3D model for the filter&TVS diff pair chips, the perimeter balls are not very noticable at this shrunken scale and can be replaced later on (placeholder).

Remove emcr_mx8m.* files as they're no longer used, rename Purism_landscape.kicad_wks file to purism_landscape.kicad_wks (prefer all lower case letter for ease of use)

Make all differential pair signal names end in P/N so that diff routing works when in layout