Dennis Field / dvk-mx8m-bsb - History

Add pull-up resistor to nCS pin of the NOR flash chip, make electrolytic caps tantalums again due to a the price difference not being significant

Add mounting holes to the schematic and assign the associated M2 hole footprint, add fiducial marks to schematic and assign the associated 1mm diameter copper with 2mm diameter solder mask opening footprint, make various visual adjustments throughout the schematic

For better BoM generation, added placeholders for SOM, disṕlay, camera, WWAN card and wifi/BT card.
Datasheet links and supplier information can be stored in these new library symbols.

Add FDV301N footprint based on the manufacturer's given recommended land pattern, use lower ESR 220uF tantalum capacitors in place of previously selected ones, re-export the BoM

Double checked FET footprints to make sure those assigned to the official SOT-23 footprint are correct.

Use PTN36043BXY part number instead of PTN36043BXZ due to availability

The only difference between these two part numbers is the reel the chip comes in, both are identical ICs.

Assign u.FL to the coax connectors in the WLAN+BT circuit

added missing ground/shielding connections for connector J201 (USB-C)

Add BLM18PG121SN1D chip ferrite beads to the GNSS, proximity+ambient light sensor, and IMU +3.3V power pins

Add MIC2876 5V boost converter's footprint, assign it, assign it the DFN-8 3D model