Dennis Field / dvk-mx8m-bsb - History

Rotate the haptic motor in order to minimize its wires' proximity to the USB-C diff pairs on the back

Lay out the rest of the 3V3 and 3V3_P circuits, route the PWR_EN to the 3V3_P power switch IC, lay out & route the reset button's circuit

Begin routing the 3V3 buck converter circuit, make all SMD footprints defined as SMD footprints instead of THT

Add via stitching fence around the baseband modem antenna and its feedline

Routing of various signal (HMDI_CEC, SD2_RST, SYS_RST, ONOFF, ..)

Route the ONOFF net

Unrouted count is now down to 543.

Place and route the ON/OFF & volume buttons and their circuit

Route the rest of the camera circuit, add meanders to the clock and D1 diff pairs so that the skew between the clock and data-lines is 0 (still need to do intra-pair skew/phase), add the pull-up resistors to I2C3, add a 3V3_P filled zone around the whole board on the In3.Cu layer