Dennis Field / dvk-mx8m-bsb - History

Bring the SD controller's WP pin to GND

The WP pin needs to be brought to ground for the write protect to not be enabled by the chip.

Use the new MDT320E03001 M.2 socket footprint in the layout, make the corresponding changes in the layout for this new footprint to work

This M.2 socket is used instead of the previous one due to the M.2 module having components on the back which are as tall as 1.35mm.

Bring the HDMI diff pair shield pins directly to GND instead of the 0Ohm resistor which goes to GND

Straighten out a couple of traces such that they don't have unnecessary bends

Move FB1605's silkscreen reference designator out of the mPCIe mounting hole

Since MISO/MOSI are correct on the upcoming prototypes then there's no need to point out the old error in the pinout spreadsheet, remove this remark in the spreadsheet

Fix the Mini-HDMI pinout such that it correctly matches the standard

Re-exported the gerber files (fabrication drawing will need to be reproduced too).

Improve some more of the routing, remove a pointless stub found on the CAPTOUCH_~INT net

Increase the UIM-PWR via size near the SIM card socket, re-export all of the manufacturing files which this change affects (fabrication drawings and gerbers)