Dennis Field / dvk-mx8m-bsb - History

Assign most of the capacitors their respective footprints (most are 0603s), add camera/CSI connector component info, source cheaper distributors for 3.5mm headset jack and RJ45

Add notes regarding I2C's 3V3_OUT supply and the fact that it is sourced from NVCC_3P3 (3A BUCK6), add additional notes regarding the RTC and Camera's I2C slave address, reannotate the whole schematic (nearly the last time)

Include address in schematic notes for all I2C1 slaves, make HDMI connector shielding resistor to GND 0Ohms

Add IRQ# signal coming from the RTC, go over the SoM pins and fix lingering errors that are found

Modify the CSI circuit to use a 02x15 connector for potential use with the CO8725-B5SA-E camera, include cap touch FPC connector details, make minor adjustments to GNSS antenna circuit

Add WWAN and WLAN+BT MHF4 coax connectors and antennae symbols to the schematic, remove home and back buttons, reorder sheets so that GNSS is above the haptic motor sheet

Assign UART3 to the GNSS module, remove this UART3 from the WWAN M.2 and assign GPIO5_IO03 to DPR

modifications to library symbol and footprint of ethernet magjack

Begin GNSS schematic using MAX-M8 module

Since UART2 isn't brought out then will either need to use UART1 (debug) with jumpers or the module's I2C interface.

Resolve merge conflict after pulling recent commit, now can no longer use SSH (since Gogs is getting abandoned?).

added footprints for switches and phone jack
new wiring of DPDT switches for HKS purposes