Capacitor board version 3, final kicker prototype. Capacitor board changed to two wire connection. Discharge circuit upgraded on main board to give 8s discharge (down from 3 minutes). Separate discharge circuit not needed for this reason. Wiring on main board completed.

Added measurements from kicker board kicker board 2013 with extra capacitor

New kicker version Added Debug buttons and added discharge circuitry. Revised errors of previous board.

Changes

Changed 10k resistor to 16.2 resistor on kicker voltage measurement

Connect Shunt to ATTiny Connects the Shunt Resistor to pin 13 of the ATTiny in order to measure the voltage of the kicker capacitors.

changed MCU to ATtiny 441

prototype for rgb-led project rev-a assumes a single copper layer implementation

allowed thermals on XT-60

disabled thermals on shorting pads