t3ddftw / BlueBus - History

[IMP] aplication: 1.0.9
* Improved the CD Changer emulation code
* Resolved issues with the CD53 display being cleared and not re-written sometimes
* Resolved issues with dimmer status not being correctly sent back to the LCM when using one touch blinkers
* The CLI will now display a prompt
* The CLI is no longer case sensitive
* The CLI will display a banner when the enter key is hit and no activity has been seen for over 5 minutes
* The "VERSION" command has been added to check the hardware and software version
* The backspace key is now supported in the CLI!
* CD Changer emulation is now 100% per the spec
* Summoning Siri/Goog Assistant is now available in any radio mode, if you have the TCU emulation wired up

[IMP] hardware: Minor Rev C updates
* Route TX/RX LED signals to correct LED
* 25LC1024 swap
* Align OSHW / BlueBus Logo correctly

[IMP] utility: Bootloader tool improvement

* Update for 1.3 bootloader
* Lower timeout
* Move Platform request a little past the Serial() init

[IMP] application: 1.0.8 Improvements

* Add call handling for TCU emulation
* Restructure BT commands in CLI
* Do not reattempt to shut down the unit if the line is already low.
* Add version command to CLI and BC127 API

[IMP] bootloader: Usability improvements
* Flash LED while in Bootloader mode
* Remove block to listen for updates from BC127
* Add code to catch Bootloader in BC127 mode
* Set BC127 into data mode when in BC127 bootloader mode

[IMP] application: v1.0.8 improvements
* Add trap counter
* Fix issues with BC127 notification parsing
* Fix I2C issues
* Fix issues with WM8804 & PCM5102A
* Add code to power unit off after given timeout

[IMP] bootloader: Improvements
* Add catch for recovery pin
* Remove Bootloader timeout for message processing
* Put BC127 into data mode
* Add trap catches

[IMP] application: Version 1.0.8
* Add code to handle I2C
* Add code to handle WM8804
* Add the beginning support for the Busines Navigation
* Attempt to stop the BMBT from being overwritten
* Add code to test Telephone and Power off to CLI
* Improve EEPROM handling
* Improve Config setting handling
* Remove DAC Keepalive

[IMP] hardware: Rev C
* Add TL064A to reduce IBus noise and attenuate the gain of the DAC
* Add WM8804 to convert S/PDIF to I2S
* Add circuitry to emulate factory Telephone
* Add connector for factory telephone
* Add circuitry to drive the OE Microphone
* Add CE symbol
* Add ability to shut off the board via the TH3122

[IMP] hardware: BlueBus Rev C
* Add MOSFETs to handle TCU ON / Mute Signaling
* Add PAM8406 for call audio output
* Add WM8804 for S/PDIF to I2S conversion so that both S/PDIF and I2S can be available at the same time
* Use PCM5122A with I2C mode
* Add microphone input jack
* Update USB jack to use a through-hole connector
* Add cut-out for 6-pin connector snap clip