t3ddftw / BlueBus - History

[IMP] bootloader: Recovery Jumper Change

* Set recovery jumper to on only when connected
* Shutdown the PAM amplifier in bootloader mode as well

[FIX] application: 1.0.9.11

* Fix UI Flicker issues on BMBT
* Fix issues with device connectivity in UI
* Add code to handle DTR signal
* Add PCM5122 support
* Fix issues with large metadata crashing unit due to stack overflow
* Add a timer to trap catches before resetting

[IMP] hardware: Rev D

* Remove TL064A
* Remove associated passives
* Remove PCM5102 and add PCM5122 in I2C Mode
* Change output filter on PCM5122 for a higher load
* Re-layout the telephone IO components
* Move Logo
* Rev to D
* Add decently sized and plated mounting holes

[FIX] utility: Add Requirements & PyEnv

* Add requirements.txt
* Update Sha-bang to use env rather than the direct python binary

[IMP] firmware: Application Improvements

* Fix MID support
* Fix sleep issues
* Fix some device selection issues

[IMP] hardware: Add Drill Legend & Connect DTR

* Add Drill Legend and Drawing info for PCB manufacture
* Connect DTR pin on FT232RL to PIC24 for terminal detection
* Condense Parts list

[FIX] firmware: Application fixes

* Log Call start / call end
* Always rewrite menu on C43 radios

[IMP] hardware: Rev C Updates

* Ground Shields for USB and S/PDIF
* Wire S/PDIF directly to WM8804 output
* Replace Microphone resistor with 2kohm
* Replace output load impedance resistors on Audio with 110ohm

[FIX] firmware: Application 1.0.9.4

* Handle CDC Pause correctly
* Remove frivolous instances of the Radio screen alteration command
* Refresh menu immediately, rather than via timeout

[IMP] firmware: Application 1.0.9.3

* Enhance C43 support
* Resolve issues with flickering UI for Navigation setups
* Add Mic gain setting in CLI
* Fully support MKI/MKII/MKII older UI
* Add code to handle power off failures