TiaCSys / CoffeeCaller - History

chore: use more correct trace width for RF

For a two layer board the correct trace width for 50 Ohms should be
around 2,7 mm. This is quite thick and doesn't connect well to the
existing pads. Therefore it's reduced to 1,7 mm as mentioned in the
datasheet for the antenna.

Also a test point is added to connect analyzers directly to the RF
output.

fix: use correct pinning for LDO

The LDO was incorrectly in the Database so that Vin and Vout switched
positions. This leads to incorrect functioning of the LDO - basically as
a diode dropping the voltage by 0,7 V