v0.3.3: Final version for BMS challenge with EnAccess Updates compared to v0.3.2: - Optimization of some copper planes - Net tie with thicker connection to GND - D12 connected to Bat- No parts were changed, the BOM is same as before.

v3.2.2: Switch to SMD terminals instead of press-fit Rationale: These are easier to manufacture (no additional step required) and the PCB can be mounted onto a heat sink without any milling required.

Add ESP32-C3 and switch part numbers

Board v0.3.1: Add test point for GPIO9 (BOOT) pin Fixes #34

BOM updates with a few more alternative parts

Major update for BMS C1 v0.3 This commit contains major updates of the PCB after the first prototype build-up and testing. Changes include: - Single PCB instead of stacked PCBs to simplify design and reduce cost. - STM32 MCU was removed due to supply shortage. Only ESP32-C3 supported. - Custom connectors replaced with off-the-shelf Würth Power Elements. - 5V power rail removed to simplify design (CAN runs on 3V3 transceiver). - Larger Shunt with improved footprint. - Optimized layout to reduce distance between IC and shunt.