Martin ROGER / VXDash - History

Update VXDash.ino

Introduction of raw values with correct type, sent to screen.

HMI adaptation + serial debug

- HMI showing raw values
- Pulsator with normal serial
- Duty Cycle pot enabled 20 -> 80
- ESP sends raw values but not scaled currently

Minor changes, ADC correction

- R4 ADC pin was not correctly set
- logic on the overheat lamp

Minor corrections

- C35 and C36 were swapped on the silkscreen
- RV1 holes were too small, enlarged to 0.85mm
- Regenerated BOM and schematic files
- Updated HMI and Code to latest versions from benchboard

Merge pull request #29 from martinroger/Martin-dev

Housekeeping update - 1.2.2

Reverted GND plane thermal reliefs

Everyone gets thermal reliefs... you get thermal reliefs, YOU GET THERMAL RELIEFS !

Housekeeping update - 1.2.2

Version numbers updated to 1.2.2 for the schematic and PCB
Components identified, datasheet and descriptions updated
iBOM regenerated
PCB plots regenerated
PCB :
- only thermal reliefs on PTH, not on SMD pads
- couple GND islands taken care of
- couple rationalisations on the 3v3 rails

GND fill thermal reliefs

Changed the GND plane fill to thermal relief to aid manufacture

PCB update

Includes 12V switcher updates plus other tweaks and additional ground stitching