Solar Car at UVa / Rivanna2S - History

Precharge resistor traces moved off of heat sink.

Moved the all pin 2 resistor connections to pin 3 in the schematic. This should connect traces to negative terminal of resistor instead of the heat sink.

Change precharge to 2s by 5p resistor configuration.

Change precharge board to 2 series by 5 parallel resistor configuration with addition increase in trace width.

Replaced resistors (500 ohm to 470)

Replace the 500 ohm, 25W resistors for 470 ohm, 35W due to parts availability. Further, cleaned up courtyard for new footprints.

Set origin point

Set the origin point to bottom left corner of cut edge.

Origin point set

Set origin to bottom left corner of cut edge.

Courtyard updated

Removed duplicate courtyard for power resistors.

Silkscreen edited

Warnings for silkscreen overlap addressed as well as trace length on J6 Pad2.