fabrication output

changed ADA4841 footprint

Changed the board outline The board outline was changed to be exactly 115 mm x 32 mm. Other boards will be standardised to 32 mm width

Upgraded nano-fit connector (1x07) Changed the RS485 BUS connector (molex nano-fit) from 1x05 to 1x07 to make it easier to daisy chain the boards together

Fixed DRC violations Fixed DRC violations based on missing footprints. Should review THVD8000 foot print as it had to be changed from 'missing' footprint import. This version passes all DRC checks. Net clearance was changed to 0.127 mm (4mill) otherwise the SOT-23 pads were failling DRC

Changed worker board layout V2 Removed micro-vias, used only two layers, changed connectors and generally re-worked the worker board

Change footprint of the single header connector

DRC clean Remove the warning by repositioning the label on both top and bottom layer Replace the +5V net for the 5V net

Replace label in only 2 dimensions and without overlaping on traacks

updated the teensy symbol witht he G2 pin The G2 pin can now be connected to GND directly in the pcb without the need of a via