Added M3 via and GNd pin Reshape for 35 mm width

Verification of all pins of the LT7101 According to the datasheet and DC2895A demoboard

Added logo and board cutout

Place new molex connector on board Molex 2 positions connector for 12V and A-B connections

Added simulation in kicad to the power_supply

Moved text reference

Added via to bottom ground plane DRC, via to GND and 3D model

Finished connection and zone The Vbb and Vin have returned to separate nets and zones. In this configuration the spike of volage when turning on the source at the surface will be handle by C1,C2 and C3.

Plane configuration The Vin and Vbb are merged into a single net. Is the C1 to C3 usefull then? Must revise the decoupling strategy

Preliminary placement of components on the power supply board 3 planes are : Vbb or Vin, GND (top and bottom) and Vout