Rename nets to reference their jumper pairs
Hopefully this will make things clearer, especially tools give false
positives about shorts
by
Joel Bradshaw
2 years 6 months
Use maskless bridged jumpers
These aren't in the standard library yet but I opened a PR to add them
by
Joel Bradshaw
2 years 6 months
Add more jumpers for Teensy++ 2.0 compat
This avoids requiring folks to pull pins out of headers for Teensy++ 2.0
compatibility, instead just requiring them to cut the traces, which I
think is better and more importantly is reversible, so that if someone
builds with a Teensy++ 2.0 and then wants to replace it with a 3.6, they
can just re-close the new jumpers, desolder the old ones, and be good to
go.
by
Joel Bradshaw
2 years 10 months
Update to the new project file format (#47)
I opened and saved the project and its schematic, PCB, etc. Some got
saved with a different file name extension.
`kinx-cache.lib` had to been renamed to `kint-cache.lib` otherwise the
Schematic editor would complain that the file is missing. Then I
removed it as I was told in the IRC channel that after saving the
schematic in the new format, the symbols will be embedded and it's no
longer needed.
When opening the PCB there was a warning:
> If the zones on this board are refilled the Copper Edge Clearance
> setting will be used (see Board Setup > Design Rules > Constraints).
> This may result in different fills from previous KiCad versions which
> used the line thicknesses of the board boundary on the Edge Cuts
> layer.
The File > Board Setup > Design Rules > Constraints > Copper Edge
Clearance is 0.05mm. Clicking the board boundary belonging to the Edge
Cuts layer reveals a properties dialog with Line Width 0.05mm.
Being the same, nothing should change at the next refill.
The `.gitignore` file has been updated from its original source.
by
aleb
2 years 10 months
Update README.md (#44)
https://forum.kicad.info/t/warning-avoid-all-links-to-kicad-pcb-org-use-kicad-org/31521
by
ferdymercury
3 years 3 weeks
- 1 of 100
- ››