README.md
Ambus---UPPSU

View this project on CADLAB.io.

Ambus Commands




  
Command
  
Description




  
DEV?
  
get device description


  
FW?
  
get firmware version


  
SWITCH?
  
get HW switch state


  
MODE?
  
get CC/CV mode


  
VOLT?
  
get measured output volrage


  
CURR?
  
get measured output current


  
SETV(?)
  
set(get) output voltage


  
SETC(?)
  
set(get) output current


  
SWREM(?)
  
set(get) remote output control


  
OUTPUT?
  
get output relay state


  
CALVG(?)
  
set(get) calibration voltage gain


  
CALVO(?)
  
set(get) calibration voltage offset


  
CALIG(?)
  
set(get) calibration current gain


  
CALIO(?)
  
set(get) calibration current offset


  
SAVE
  
save settings to EEPROM


  
LOAD
  
load settings from EEPROM