Steven Cooreman / AMS2ZWAVE - History

Set UART priorities lower than the radio's

Could potentially solve the hanging mystery?

Temporarily piggyback off of voltage and current for debugging

Hopefully I can figure out why it was halting without having to
stand outside in the cold for hours with a debugger.

It's *still* extremely cold outside and resetting every 2-3h wasn't enough

It's minus 10 degrees outside and I don't want to freeze

Postponing debugging to a warmer season. This workaround is good
enough, and nobody is ever likely to notice.

Added missing 3D models for SMA and RJ45 connectors

Update to proto v2

* Added test points for LGA pads bordering on in-use pads, to avoid them from coming loose when too much heat is applied
* Moved SMA edge connector around, it makes more sense to have it at the top
* Tidied layout

Update to proto v2

* Added edgemount SMA in addition to U.FL for antenna flexibility

Update to v2 PCB

* Increased DCDC switching frequency to 600kHz
* Added resistor divider for setting UVLO to 10V
* Added solderjumper for DCDC mode
* Added bulk capacitor to smooth out 12V swings on the input line

Merge pull request #3 from stevew817/fix_bulk_report_2

Apply second round of feedback for Configuration CC bulk report