revC2: Updated 1b2-bom-keys and corrected levelshifter PN.

revC2: Increased tact switch slot width. Now the slot width is the same 0.6mm as the USB-C connector which is known to work even with JLCPCB. JLCPCB officially states that the slot width should be 0.65mm, though we know they are fine with the narrower USB-C slot too.

revC2: Corrected the reset button 3d model.

revC2: added reset button 3d model.

revC2: Increased the solder paste apertures for paste in hole. Extended the apertures for the USB-C and Tact switch shield through holes. This should provide a bigger amount of solder for the through holes. (Might require additional tweaking down the road)

revC2: Added copper fills to anchor the USB-C connector better. Added copper flood fills on all PCB layers to make a more positive anchor of the shield tab through holes to the PCB layers. Also enabled solder paste aperture openings for the shield pads. Tested on other projects I know that paste in hole works for these connectors.

revC2: Improved anchor of the tact switch shield to the PCB. We now have through hole slots that will solder to the metal shield tabs of the tact switch. This will securely anchor the tact switch to the PCB.

revC2: Replaced top actuated tact switch with a side actuated one. This should make the case design better. This is not necessarily the final tact switch selection.

revC2: add some more documentation about reset to the schematics

revC2: add more vias to layer changes of the main +5V rail