Glasgow Embedded / Glasgow - History

revC2: Generated gerber, bom and renderings.

Additionally, the glasgow subdirectory README now contains information
on how to generate the 3d renderings included in the glasgow repository.

applet.interface.ps2_host: add missing guard state change.

revC2: fix level shifter MPN

Thanks @gregdavill for spotting & reporting this.

revC2: Removed the solder mask minimum width setting.

As recommended by KiCad this setting should only be used when explicitly
asked by the PCB manufacturer. It depends on their needs and
capabilities and is usually done as part of gerber file pre processing
done by the PCB manufacturer.

revC2: Moved the front mfr logo anchor to a better spot.

revC2: Corrected resistor pack footprints.

The outer pads of the resistor pack footprints were slightly too small.
This can cause assembly reliability isues.

revC2: Corrected the SOT-143 footprint.

The footprint in the KiCad library works but it is too large and could
cause assembly reliability issues. The new footprint and 3D model are
based on the official Diodes Inc data and match the part we are using.

revC2: Minor footprint type corrections.

The reset button had to be TH. Logos should be virtual.

revC2: add dimension drawings for the mounting holes

revC2: re-route ~MR trace on the bottom layer to not split the GND plane below voltage regulators