test-jig: all tracks routed
by electronic_eel 5 years 4 months
test-jig: reduce space needed for testpoints and solderjumper - use smaller solderjumpers footprints - 2 solderjumpers for I2C address selection instead of solderjumper + testpoint - smaller testpoint footprints
by electronic_eel 5 years 4 months
test-jig: re-orient some of the connectors to better match the intended layout
by electronic_eel 5 years 4 months
test-jig: use smaller footprints for '4066 and '2G14
by electronic_eel 5 years 5 months
test-jig: add terminal block footprint (Metz AST04106) and assign it
by electronic_eel 5 years 5 months
test-jig: assign footprints (except terminals to pogo pins)
by electronic_eel 5 years 5 months
test-jig schematics: further reduce bom count change all connectors to pogo pins to ones with 6 connections. Will probably use some lever-type terminals like Wago 233 or Metz AST 041 for these. The 6 connection ones are easier to source for both types.
by electronic_eel 5 years 5 months
test-jig schematics: change from start button to a power switch with autodetect Powering off the jig & dut will prevent any glitches due to contact bounce and similar effects.
by electronic_eel 5 years 5 months
test-jig schematics: small improvements
by electronic_eel 5 years 5 months
test-jig schematics: annotate and ERC fixup
by electronic_eel 5 years 5 months
Report a bug