-Added DMA support by including a trace.It can be undone by cutting the normally closed side of the jumper and soldering the normally open -Added a normally open solder jumper to short out C62 if one wanted to power the coco 3 directly with DC

Added a pull up resistor to SELA so that the new replacement PIA's are more compatible

-Updated pcb version number -moved component references and values to F. Silk -adjusted the position of some components

moved value to F silk

added cap value to silkscreen

-Fixed R/W line not connected from the GIME to the CPU

moved some stuf around and rerouted some traces

-added 3d model -rotated CN7 -routed the board

added OSH logo

fixed rf can footprint and rca plug footprints.