Dennis Field / dvk-mx8m-bsb - History

Modify the boot config/boot mode pins and switch such that only eMMC and USB (serial downloader) are boot options due to the uSD being attached to the USB<->SD bridge chip, add OV5460 notes about using the internal DVDD 1.5V regulator

Make changes to the USB hub + SD bridge circuit and uSD sheet based on Prolific's feedback after asking questions

Add smart card circuit using the SEC1110 USB to ISO/IEC 7816 bridge chip, include ID-0001/2FF/mini-SIM socket connector selection informatino (1010027182)

Need to create footprint for the mini-SIM socket

Add Prolific MA8627 USB hub + SDIO bridge chip and use it in place of the USB2660, SD interface used with the uSD (not WLAN)

added outline of display into footprint directory (drawing in fabrication layer only)
(usable only for pcb size estimations)

Move MIPI DSI & CSI sheets into a "MIPI" sheet, both DSI and CSI will likely use the I2C level shifter

Begin assigning footprints to passive components, add component information to the common 10k resistors throughout the schematic, include TVS diodes on the switch/button I/O pins, use the DB2J20900L schottky diode throughout the design (in place of the ZLLS400)

Added notes about the battery holder, battery size, and the fact that the 103HT thermistor can fit underneath the 18650 battery when the battery is insterted into the holder.

Included frequency response curve for the new/cheaper SMD speaker (slightly thicker mechanical dimension).

Included note about the RedPine RS9116's SDIO_RESET# line expecting a 2.31V VIH logic level, increased the pull-up to 100k (M.2 standard states that this is should be 1.8V level).

Added a TODO note stating the 1.8V logic-level I2C devices should share the same level-shifter that will be on the top-level circuit (in next commit).