Dennis Field / dvk-mx8m-bsb - History

added company logo and designers email addresses into drawing area
new library with symbol of Emcraft-SOM (for later use)

Add haptic motor and debug UART headers/connectors, include notes in schematic r
egarding the DPDT switches' & logic gates' pins being interchangeable

Used right-angled JST 2.5mm connector scaled in half as the motor connector footprint & 3D model, included 1cm distance from haptic motor placement from the edge of the connector (shown on silkscreen).

Add quartz crystal footprints, reassign BHC-18650-1P footprint & associated component properties, add BHC-18650-1P 3D model

Add FET (Q* reference designators) footprints

Some footprints are slightly edited versions of their KiCad official library equivalents, using the existing 3D models. DMG2301L's SOT-23 footprint is identical to the official one in the KiCad library.

Connect VCC of the USB1_VBUS comparitor (TLV3201AIDBVR) to 5V_SOM instead of 5V_P so that VBUS presence can be detected quickly enough for the USB Serial Downloader bootmode, connect the TVS diodes on the HDMI receptacle to the proper pins

Add 103HT thermistor footprint and 3D model which is used to monitor the 18650 battery temperature (will be located right under the batter within the holder)

Used the SOD-123 model, added a thin layer on top of it to cover the polarity marking in FreeCAD, scaled the model in KiCad by 0.4.

Add polyfuse/PTC resettable fuse footprints and 3D models

Assign footprints and component properties to all diodes (including LEDs)

Using Lite-On's LTST-C190GKT (0603, 2.1V @ 20mA) instead of Broadcom's HSMG-C170 (0805, 2.2V @ 20mA) in the ethernet circuit.