Dennis Field / dvk-mx8m-bsb - History

Re-assigned footprints to the SOM after changes in the library symbol

Add AC coupling caps to the HDMI_AUXP/N diff pair which were mistakenly left out, fix a couple typos/errors that were made when transitioning to the new top-leve sheet, make the M.2s' I2C RX TX hierarchical signals consistent and clearer

Hopefully all lingering errors have been caught, this will likely be the schematic commit that gets reviewed (fingers crossed).

Assign TLV3201AIDBVR footprint based on the SOT-23-5 official footprint using the given solder mask clearance and pad clearance parameters, assign the QFN48 3D model to the ETH PHY footprint, make some minor adjustments to the front sheet's layout

Create AP22814 footprint and assign it to the respective symbols, use DFN-6-1EP_2x2mm_Pitch0.65mm 3D module for AP22814

Reorder USB-C's diff pairs based on layout simplicity as done on EmCraft's Rev 2 baseboard (requires Lane Polarity Inversion), add 2 and 3-channel differential filter & TVS IC footprints (used with USB-C and HDMI), import USB-C receptacle 3D model

Used a scaled version BGA-256_16x16_17.0x17.0mm_Pitch1.0mm 3D model for the filter&TVS diff pair chips, the perimeter balls are not very noticable at this shrunken scale and can be replaced later on (placeholder).

Move haptic motor connector footprint position such that 0,0 is between the through hole, this should make it so that its placement coordinates is closer to its center of mass

Remove emcr_mx8m.* files as they're no longer used, rename Purism_landscape.kicad_wks file to purism_landscape.kicad_wks (prefer all lower case letter for ease of use)

Rename MAX-8 back to MAX-M8 (all references now MAX-M8)

Make all differential pair signal names end in P/N so that diff routing works when in layout