Dennis Field / dvk-mx8m-bsb - History

Specify the common name of the display manufacturer in the schematic notes

Remove a redundant 3V3_P via near the M.2 footprint which is no longer being used

Add a note in the schematics about the LCD using the Sitronix ST7703 display driver IC

Bring the SD controller's WP pin to GND

The WP pin needs to be brought to ground for the write protect to not be enabled by the chip.

Use the new MDT320E03001 M.2 socket footprint in the layout, make the corresponding changes in the layout for this new footprint to work

This M.2 socket is used instead of the previous one due to the M.2 module having components on the back which are as tall as 1.35mm.

Add MDT320E03001 M.2 Key E socket footprint and 3D model

Bring the HDMI diff pair shield pins directly to GND instead of the 0Ohm resistor which goes to GND

Color the pins orange and dark-orange in the pinout spreadsheet for the pins which would critically conflict with EmCraft's basebaord device tree (resulting in an output connected to an output)