Dennis Field / dvk-mx8m-bsb - History

Nearly complete the LCD/DSI and cap-touch schematic, add notes from the display's datasheet regarding the various pin assignments, add component property information for the 39-pin DSI clamshell connector

Still need to determine what this requested "low power state signal" requirement is for the display.

Modify the boot config/boot mode pins and switch such that only eMMC and USB (serial downloader) are boot options due to the uSD being attached to the USB<->SD bridge chip, add OV5460 notes about using the internal DVDD 1.5V regulator

Add smart card circuit using the SEC1110 USB to ISO/IEC 7816 bridge chip, include ID-0001/2FF/mini-SIM socket connector selection informatino (1010027182)

Need to create footprint for the mini-SIM socket

Move MIPI DSI & CSI sheets into a "MIPI" sheet, both DSI and CSI will likely use the I2C level shifter

Begin assigning footprints to passive components, add component information to the common 10k resistors throughout the schematic, include TVS diodes on the switch/button I/O pins, use the DB2J20900L schottky diode throughout the design (in place of the ZLLS400)

Added notes about the battery holder, battery size, and the fact that the 103HT thermistor can fit underneath the 18650 battery when the battery is insterted into the holder.

Included frequency response curve for the new/cheaper SMD speaker (slightly thicker mechanical dimension).

Included note about the RedPine RS9116's SDIO_RESET# line expecting a 2.31V VIH logic level, increased the pull-up to 100k (M.2 standard states that this is should be 1.8V level).

Added a TODO note stating the 1.8V logic-level I2C devices should share the same level-shifter that will be on the top-level circuit (in next commit).

Add MIPI CSI sheet (contents need to be added once camera selection is complete)

Flip the direction of FULL_CARD_POWER_OFF# and W_DISABLE*# switches such that the devices are on when the switch is open, this should ever so slightly reduce the power consumption when these devices are used (most likely more often than them being off)

Connect the USB/SDIO bridge to WLAN rather than the uSD, fix a few ERC violations (not has zero errors/warnings), use best schottky option

Added schematic page with USB hub/SD Card controller USB2660
deleted old USB hub and SDIO demultiplexer