Dennis Field / dvk-mx8m-bsb - History

In preperation for the final order, re-export all the manufacturing files using the current date and rev number v1.0.0

Add the fab's stackup, panel array working files, and their CPW calculations

TCPC_nINT is _not_ tied to CHRG_nINT so remove the schematic note that said they were

Make the backlight boost converter compensation capacitor (C459) 10nF instead of 100nF (was a typo), make the charge controller's PMID capacitor (C302) 10uF instead of 8.2uF since it is a more common value and is what is being used on the charge controller's eval board, select a 10uF 0603 X5R capacitor rated for 25V for both the PMID cap and the 10uF cap on VBUS, update the .ods BoM with tolerances & ratings for the caps and resistors which will be supplied by the PCBA house, export the component-placement-list file (dvk-mx8m-bsb-all.pos) which gives the coordinates of all components with respect to the top-left fiducial mark, re-export the gerbers for preliminary review (add silkscreen which states that this is preliminary instead of a version number), make a few minor improvements to the board's routing in various spots, update the IMU footprint so that its silkscreen which gives the axis directions is visible on the board, some footprints were updated to be defined as SMD footprints in order to show up on the component-placement list (strictly through-hole components are not listed)

The 0603 10uF 25V caps have been ordered and will be shipped to wherever the assembly is done. This commit contains the preliminary materials which will be reviewed (BoM, .pos file, and gerbers all zipped).

Make the ENET_* traces on the top layer 53mils in order to ensure they have a 50Ohm single-ended impedence, move one of the 5V_P bypass caps close to the SoM end of the USB2 diff pair, add meanders to the ENET_TXC, ENET_TX_CTL, ENET_RX_CTL in order to ensure these segments are matched to the long ENET_RXC segment (56.051mm, the rest of the RGMII signals are <10mm skew from this length and don't need adjusting, re-route the SIM card such that UIM-RESET is routed in between UIM-CLK and UIM-DATA as recommended by a BB manufacturer

Add pi-matching circuit to the baseband modem antenna's feedline

The return path for the antenna may have to have a 6.8nH Murata LQG15HN inductor installed on it (cutting the ground trace shorting the pads). The BoM was updated with the new components and everything was reannotated and updated (page 2's caps were out of order).

Change all 0603 capacitors _EXCEPT_ the 2.2uF, 4.7uF, 8.2uF, 10uF, and 22uF caps to 0402

Update the schematic symbols and footprints after upgrading to KiCad 5.0.0, fix all ERC and DRC violations after the new update/upgrade

Move the charge controller, USB-C TCPC, and RTC to I2C1

Since each of these ICs will be powered at the same time as the SoM regardless of the PWR_EN state, they should share the same I2C bus as the PMIC.