Dennis Field / dvk-mx8m-bsb - History

In preperation for the final order, re-export all the manufacturing files using the current date and rev number v1.0.0

Add the fab's stackup, panel array working files, and their CPW calculations

Update schematic comment to state "TUSB546A-DCI can be used for HDMI over USB-C"

Bring the HDMI diff pair shield pins directly to GND instead of the 0Ohm resistor which goes to GND

Fix the Mini-HDMI pinout such that it correctly matches the standard

Re-exported the gerber files (fabrication drawing will need to be reproduced too).

Make the ENET_* traces on the top layer 53mils in order to ensure they have a 50Ohm single-ended impedence, move one of the 5V_P bypass caps close to the SoM end of the USB2 diff pair, add meanders to the ENET_TXC, ENET_TX_CTL, ENET_RX_CTL in order to ensure these segments are matched to the long ENET_RXC segment (56.051mm, the rest of the RGMII signals are <10mm skew from this length and don't need adjusting, re-route the SIM card such that UIM-RESET is routed in between UIM-CLK and UIM-DATA as recommended by a BB manufacturer

Add pi-matching circuit to the baseband modem antenna's feedline

The return path for the antenna may have to have a 6.8nH Murata LQG15HN inductor installed on it (cutting the ground trace shorting the pads). The BoM was updated with the new components and everything was reannotated and updated (page 2's caps were out of order).

Coarsely route HDMI diff pairs from the SoM to the CMF&ESD chips, place the microphone in a position that does not interfere with either the HDMI circuit or the RJ45

The HDMI diff pairs will need to try to have 30mil clearance between each other at every point possible, in tight spaces this is not possible, even spacing will need to be adjusted in the following commit.

Begin routing the HDMI circuit

Needed to create the HDMI_HEAC_P/N labels to route Utility&HPD as diff pairs. Made cap C1905 NC, which is in parallel with a 0Ohm resistor between the HDMI sheilding and GND.

Change all 0603 capacitors _EXCEPT_ the 2.2uF, 4.7uF, 8.2uF, 10uF, and 22uF caps to 0402