Dennis Field / dvk-mx8m-bsb - History

Assign u.FL to the coax connectors in the WLAN+BT circuit

Add BLM18PG121SN1D chip ferrite beads to the GNSS, proximity+ambient light sensor, and IMU +3.3V power pins

Add MIC2876 5V boost converter's footprint, assign it, assign it the DFN-8 3D model

Add BQ25896 footprint and assign its 3D model to the QFN24 official model

Re-export the BoM after bring the WLAN+BT M.2 sheet to page 18 and redoing the reference designator numbers.

Derive the GNSS module's power from 3V3_P instead of 3V3

Move the WLAN+BT M.2 sheet back to page 18 rather than the last page (24)

Add AC coupling caps to the HDMI_AUXP/N diff pair which were mistakenly left out, fix a couple typos/errors that were made when transitioning to the new top-leve sheet, make the M.2s' I2C RX TX hierarchical signals consistent and clearer

Hopefully all lingering errors have been caught, this will likely be the schematic commit that gets reviewed (fingers crossed).

Assign TLV3201AIDBVR footprint based on the SOT-23-5 official footprint using the given solder mask clearance and pad clearance parameters, assign the QFN48 3D model to the ETH PHY footprint, make some minor adjustments to the front sheet's layout

Rename MAX-8 back to MAX-M8 (all references now MAX-M8)