In preperation for the final order, re-export all the manufacturing files using the current date and rev number v1.0.0

Make the ENET_* traces on the top layer 53mils in order to ensure they have a 50Ohm single-ended impedence, move one of the 5V_P bypass caps close to the SoM end of the USB2 diff pair, add meanders to the ENET_TXC, ENET_TX_CTL, ENET_RX_CTL in order to ensure these segments are matched to the long ENET_RXC segment (56.051mm, the rest of the RGMII signals are <10mm skew from this length and don't need adjusting, re-route the SIM card such that UIM-RESET is routed in between UIM-CLK and UIM-DATA as recommended by a BB manufacturer

Add pi-matching circuit to the baseband modem antenna's feedline

Place and route the BOOT_CFG* signals, correct a signal labelling mistake causing SAI1_RXD0 (BOOT_CFG00) to be connected to SAI1_TXD0 (BOOT_CFG08)

Change all 0603 capacitors _EXCEPT_ the 2.2uF, 4.7uF, 8.2uF, 10uF, and 22uF caps to 0402

Reduce all 0603 resistor sizes to 0402

Update the schematic symbols and footprints after upgrading to KiCad 5.0.0, fix all ERC and DRC violations after the new update/upgrade

Update project files to KiCad 5.0.0

Move the charge controller, USB-C TCPC, and RTC to I2C1

Now using GPIO5_IO03 (P4.03) to put the class-D op-amp in shutdown and conserve energy when muted, make C1716 near the ETH PHY's DVDDL pin 47 220nF instead of 10uF (EmCraft suggested that this should be 100nF but their's is 220nF, asked why), added a 10k pull-down to PAM2841's ENA pin, added a 100nF cap to the smart card's C1 VCC pin, added a 1uF cap to the haptic motor circuit's 3V3_P rail