Matthew White / Robocup PCB - History

    Close Menu
    Help
    Capacitor board version 3, final kicker prototype.
    by Sean Csukas 9 years 3 months
    Capacitor board version 3, final kicker prototype.

    Capacitor board changed to two wire connection. Discharge circuit
    upgraded on main board to give 8s discharge (down from 3 minutes).
    Separate discharge circuit not needed for this reason. Wiring on main
    board completed.
    Changes
    Files
    6d2ebaee
    Added measurements from kicker board
    by Jonathan 9 years 4 months
    Added measurements from kicker board

    kicker board 2013 with extra capacitor
    Changes
    Files
    7d8ba8f6
    New kicker version
    by Sean Csukas 9 years 4 months
    New kicker version

    Added Debug buttons and added discharge circuitry. Revised errors of
    previous board.
    Changes
    Files
    7b3aeb40
    Changes
    by danbudanov 9 years 5 months
    Changes
    Files
    4c5c02e0
    Changed 10k resistor to 16.2 resistor on kicker vo...
    by danbudanov 9 years 5 months
    Changed 10k resistor to 16.2 resistor on kicker voltage measurement
    Changes
    Files
    62891c06
    Connect Shunt to ATTiny
    by nachos5 9 years 7 months
    Connect Shunt to ATTiny

    Connects the Shunt Resistor to pin 13 of the ATTiny in order to measure
    the voltage of the kicker capacitors.
    Changes
    Files
    4b081a49
    changed MCU to ATtiny 441
    by gtrosawa 9 years 10 months
    Changes
    Files
    0acc3e93
    prototype for rgb-led project
    by gtrosawa 9 years 10 months
    prototype for rgb-led project

    rev-a assumes a single copper layer implementation
    Changes
    Files
    173d202b
    allowed thermals on XT-60
    by gtrosawa 9 years 11 months
    Changes
    Files
    4b727632
    disabled thermals on shorting pads
    by gtrosawa 9 years 11 months
    Changes
    Files
    b418e86a
    Report a bug