vr6syncro / RGBWW Controller - History

minor corrections

mainly values to make sure the BOM is all right

minor changes

increased the size of the button text
very minor re-route of GPIO2 to resistor

minor change

one of the GND traces (between R2 and R3) underneath the top ground plane was not connected - doesn't make a change in the final board since it's one copper layer anyway.

fixed a pretty embarassing error

I had one ground trace clip one of the PWM output pads.

minor routing changes

updated a few minor routings (clr) and added some more copper areas (GND around DISABLE & D1)

cosmetical correction

beautified the crossing of RXD and TXD

updated Gerber Files and Pictures

exported Gerber Files, shot a few new pictures of the board.
Unlike the Beta Boards, this version does not have pads for an R/C snubber as I don't think it will be necessary. Also, there's a larger GND area covering the top layer input side of the circuit and the 3V3 area around C1 has been expanded..
The TXD and RXD pins have switched places, it was easier to route them like that and also, their location now crosses over with the usual USB/UART converters (straight cable run).
On the disable jumper location, the pins have also switched places, disable is now on the top, pointing away from C3