vr6syncro / RGBWW Controller - History

Update esp12_RGBWW.sch

I had added and removed a power jack.

minor update

moved one signal in the schematic, no electrical change

added three accessible GPIOs

Added header pins for GPIOS 0,2 and 16 (which are all pulled high on board).
If using Tasmota, or if we make changes to the "native" firmware, those can be used to signal via MQTT and thus to provide "local" control

minor changes

increased the size of the button text
very minor re-route of GPIO2 to resistor

minor change

one of the GND traces (between R2 and R3) underneath the top ground plane was not connected - doesn't make a change in the final board since it's one copper layer anyway.