replaced resistors with smd

added op-amps to pressire sensors and resistors to temp sensors on the vcu

added RS232 chip to the vcu

replaced resistors with smd

fixed bspd and switched to smd comparator and AND gates

not sure why its not commiting

7. Disconnect the 5V line from the motor controller output – Done both sch and brd 8. connect the motor controller throttle outputs to ground – Changed on sch not sure if connected up correctly on brd Signed-off-by: Jack Bruford

Added BSPD to VCU sch and ASS two pin screw connector

added br_press sensor to vcu and replaced fuses

added values to Capacitors around TCAN