Oxford University Racing / ECAD - History

    Close Menu
    Help
    added op-amps to pressire sensors and resistors to...
    by Rugev 6 years 1 month
    added op-amps to pressire sensors and resistors to temp sensors on the vcu
    Changes
    Files
    View circuit
    20016474
    added RS232 chip to the vcu
    by Rugev 6 years 1 month
    Changes
    Files
    View circuit
    f6b549f8
    replaced resistors with smd
    by Rugev 6 years 1 month
    Changes
    Files
    View circuit
    ff2bf755
    fixed bspd and switched to smd comparator and AND ...
    by Rugev 6 years 1 month
    fixed bspd and switched to smd comparator and AND gates
    Changes
    Files
    View circuit
    041714e3
    not sure why its not commiting
    by jackbruford 6 years 1 month
    Changes
    Files
    View circuit
    cd3a1e9c
    7. Disconnect the 5V line from the motor controlle...
    by jackbruford 6 years 2 months
    7. Disconnect the 5V line from the motor controller output – Done both sch and brd
    8. connect the motor controller throttle outputs to ground – Changed on sch not sure if connected up correctly on brd

    Signed-off-by: Jack Bruford <jack.bruford41@gmail.com>
    Changes
    Files
    View circuit
    1ff26f38
    Added BSPD to VCU sch and ASS two pin screw connec...
    by jackbruford 6 years 2 months
    Changes
    Files
    View circuit
    a100c338
    added br_press sensor to vcu and replaced fuses
    by Rugev 6 years 4 months
    Changes
    Files
    View circuit
    4251117f
    added values to Capacitors around TCAN
    by Rugev 6 years 4 months
    Changes
    Files
    View circuit
    a083c603
    updated ASS wiring on vcu
    by Rugev 6 years 4 months
    Changes
    Files
    View circuit
    6bd7458e
    Report a bug