moved components on schematics to fit printouts and added frames
Signed-off-by: Jack Bruford
by
Jack Bruford
4 years 10 months
added decoupling capacitors
by
Rugev
4 years 10 months
routed pedal board
by
Rugev
4 years 11 months
replaced resistors with smd
by
Rugev
4 years 11 months
Pedal board rerouting
by
Rugev
4 years 11 months
not sure why its not commiting
by
jackbruford
4 years 12 months
7. Disconnect the 5V line from the motor controller output – Done both sch and brd
8. connect the motor controller throttle outputs to ground – Changed on sch not sure if connected up correctly on brd
Signed-off-by: Jack Bruford
by
jackbruford
5 years 1 week
replaced fuses with correct sized ones
by
Rugev
5 years 2 months
routed pedal board
by
Rugev
5 years 2 months
removed unnecessary pulldown resistors
by
Rugev
5 years 2 months
- 1 of 100
- ››