Second iteration of TSAL schematic Added P-type MOSFET for green light, added labels for outputs

Added name tags to outputs

First iteration of TSAL schematic

not sure why its not commiting

7. Disconnect the 5V line from the motor controller output – Done both sch and brd 8. connect the motor controller throttle outputs to ground – Changed on sch not sure if connected up correctly on brd Signed-off-by: Jack Bruford

Added BSPD to VCU sch and ASS two pin screw connector

Extended the CAN bus to the batteries Signed-off-by: Jack Bruford

Top level slight changes Signed-off-by: Jack Bruford

Added TS battery, made TSMS last node on ASS, adjusted ports on current sensor and motor controllers, and IMD Signed-off-by: Jack Bruford

generated gerber for vcu and pedal board