t3ddftw / BlueBus - History

[IMP] firmware: Application Improvements

* Fix MID support
* Fix sleep issues
* Fix some device selection issues

[IMP] hardware: Add Drill Legend & Connect DTR

* Add Drill Legend and Drawing info for PCB manufacture
* Connect DTR pin on FT232RL to PIC24 for terminal detection
* Condense Parts list

[FIX] firmware: Application fixes

* Log Call start / call end
* Always rewrite menu on C43 radios

[IMP] hardware: Rev C Updates

* Ground Shields for USB and S/PDIF
* Wire S/PDIF directly to WM8804 output
* Replace Microphone resistor with 2kohm
* Replace output load impedance resistors on Audio with 110ohm

[FIX] firmware: Application 1.0.9.4

* Handle CDC Pause correctly
* Remove frivolous instances of the Radio screen alteration command
* Refresh menu immediately, rather than via timeout

[IMP] firmware: Application 1.0.9.3

* Enhance C43 support
* Resolve issues with flickering UI for Navigation setups
* Add Mic gain setting in CLI
* Fully support MKI/MKII/MKII older UI
* Add code to handle power off failures

[IMP] aplication: 1.0.9
* Improved the CD Changer emulation code
* Resolved issues with the CD53 display being cleared and not re-written sometimes
* Resolved issues with dimmer status not being correctly sent back to the LCM when using one touch blinkers
* The CLI will now display a prompt
* The CLI is no longer case sensitive
* The CLI will display a banner when the enter key is hit and no activity has been seen for over 5 minutes
* The "VERSION" command has been added to check the hardware and software version
* The backspace key is now supported in the CLI!
* CD Changer emulation is now 100% per the spec
* Summoning Siri/Goog Assistant is now available in any radio mode, if you have the TCU emulation wired up

[IMP] hardware: Minor Rev C updates
* Route TX/RX LED signals to correct LED
* 25LC1024 swap
* Align OSHW / BlueBus Logo correctly

[IMP] utility: Bootloader tool improvement

* Update for 1.3 bootloader
* Lower timeout
* Move Platform request a little past the Serial() init

[IMP] application: 1.0.8 Improvements

* Add call handling for TCU emulation
* Restructure BT commands in CLI
* Do not reattempt to shut down the unit if the line is already low.
* Add version command to CLI and BC127 API