[IMP] hardware: 1.6 * Swap out DMP32D4S for SOT-323 DMP32D4SW

[IMP] firmware: 1.1.17 * Enhancements to CD53 UI detection * Add CD53 Caller ID

[IMP] hardware: v1.6 Updates * Rewire BC127 UART * Configure BC127 power supply for fixed voltage * Add circuit for 5ms delay to VREG_EN pin of BC127

[IMP] hardware: v1.5 Updates * Replace ETQ-P4M100KFN 10uH inductor with MPL-SE5040 * Remove 100nF cap from 5v vreg output * Renumber Capacitors * Add 22uF caps to 3v3 vreg input and output for better transient response

[IMP] firmware: Application 1.1.17 * Finalize release * Fix CD53 Settings UI issues

[IMP] hardware: v1.6: Minor updates * Re-add 10k resistors to BC127 UART lines * Minor rewiring work around the TMUX154

[IMP] hardware: v1.1.6 * Re-wire BC127 power input for use with fixed regulated voltage, rather than battery power

[IMP] firmware: Application 1.1.17 beta 7 * Add Self Play ability for cars without an I-Bus Changer * Shuffle configuration parameters around

[IMP] firmware: Application 1.1.17 * I18n improvements * Catch for BC127 boot failure. Red TEL LED is now blinked to signify a fault * Added Config "Values" rather than "Settings" * Fix "Main Menu" String for BMBT * Add BC127 Boot fail counter * Remove useless linker file * Fix for newer CD53s not making use of 2 correctly * Fix for CD53 call detection. Change call state before block to ignore setting of I-Bus TEL state to "call active"

[IMP] utility: Mode Change and Python Env * Set Env to py3 * Add x bit to console_firmware_tool.py