[ADD] firmware: Production board updates * Update pin configurations * Add Prototype board configurations for pins in comments * Remove external crystal configuration and use FRC instead * Use PICKIT4 * Update Configuration to use GA606 device

[ADD] hardware: BlueBus Board rev. 5 * Add primary 8MHz oscillator * Wire EEPROM signals to compatible pins * Rewire all capacitors so they are not inline with the power rail (Mostly on MCU) * Update pins style to common size instead of the long pin pads * Update size and location of mounting holes * Rewire VIN to make room for mounting holes

[ADD] hardware: Power Management Updates * Wire 5v regulator FB pin to GND * Update BS Cap to 0.01uf from 0.1uf per the datasheet * Add 100kohm resistor to EN pin of 5v regulator * Rewire VIN and 5v Regulator * Update 0.1uF cap on VIN of 3.3v LDO to 1uF per the datasheet * Update 0.1uF cap on VOUT of 3.3v LDO to 2.2uF per the datasheet (>1.0uF required) * Rewire Power Signals so they make more sense

[ADD] hardware: BT_UART I/O Change * Re-wire BT_UART for FTDI cable compatability

[ADD] hardware: Minor board changes * Add mounting holes * Fix uneven pitch of crystal caps * Replace wide through-hole pins with standard sized ones * Update name of TPA6017A2 IC * Update trace widths for 5v rail to .55mm

[IMP] hardware: Align crystal caps on the Y-axis

[IMP] project: Update gitignore

[IMP] hardware: Remove EAGLE board revision from VCS

[ADD] hardware: BlueBus v4 Board Changes * Remove BC127 LEDs * Enlarge all IC pads to make SMD assembly easier * Rewire 3.3v Rail into a star topology to do away with potential issues from dasiy chaining * Rewire portions of the 5V rail * Rewire MIC_IN Signals to make use of stereo audio * Tighten up similar signals for better board routing * Enlarge all vias to 0.51mm * Elarge 5v rail to 0.55mm * Tent all vias for a nicer silkscreen * Update silkscreen positioning * Remove wires from under TPA6013 since it contains a thermal pad

[ADD] hardware: Update Schematic and Board * Remove local libraries that can be found by EAGLE automatically * Rewire VIN side of the board * Update D4 to be a 30V 2A Diode, instead of a 100V 250mA diode