README.txt
                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1893253
Optical Mouse by tom101222 is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is a fully functional 2 piece computer mouse to be used with my optical sensor board found on my indiegogo project listed below . There is a tab on the front of the base plate that the top shell slides into then just screw the top down with a 2.5mm x 20mm machine screw.  Print with support.

NOW AVAILABLE! I did a small production run and the sensor boards can now be found here 
https://www.tindie.com/products/tom10122/adns-3050-sensor-board/


Indiegogo  - https://www.indiegogo.com/projects/adns-3050-optical-gaming-sensor#/
Code - https://github.com/Tom101222/Adns-3050-Optical-Sensor

# Print Settings

Printer Brand: RepRap
Printer: Prusa I3
Rafts: Doesn't Matter
Supports: Yes
Resolution: .15mm
Infill: 30

# Post-Printing

## Removing support

There is support material built into the model for easier printing, the material is on both sides of the mouse buttons and under the arch for the wire. I recommend using an X-acto or some other thin blade to cut it off. The "Buttons" should move freely without clipping/hitting the rest of the frame. 

## Switches

The two buttons are mounted with 2 M2 x 20mm machine screws and nuts, solder the wires to the switch at a 90 degree angle so there is enough room.

## Board and Lens

The lens falls into place in the recessed rectangle in the middle then the sensor board goes on top of that, make sure the yellow kapton tape is removed from the sensor and that the sensor falls into the lens correctly. Then just screw the board down. 

## Top shell

The bottom baseplate tab slides into the top shell and the shell is secured with a M2.5 machine screw