Silkscreen cleanup and additional analog pin removed as many silkscreen keep out errors as possible. Added a breakout for analog pin A1 to the bottom header.

Swapped Serial1 RX and TX Fixed an issue sending / receiving serial between the atmega32u4 and ublox max m8q by swapping the rx and tx pins on the atmega32u4.

Added Pull down to HWB pin added a 10k pull down resistor to HWB to resolve issues flashing the boot loader

v2 BME280 decoupling cap added decoupling cap to bme280 of v2 board.

Tracksoar V1.3 Created a new test board Tracksoar v1.3 to resolve potential issues with the boost converter interfering with GPS reception.

Corrected battery connector placement Moved the battery connector to the bottom side of the board to avoid conflicts with the USB connector

Updated Silkscreen Updated capacitor values and schematic symbols. Updated silkscreen to remove overlaps and standardized text size.

tracksoar v2 rev 5 converted to 4 layer board, covered via with solder mask, routed vcc and gnd on internal planes. Corrected AREF connection to ground via cap. Added analog pin connection to 15v to measure battery voltage. General routing cleanup.