updated rf paths seperated RF GND from GND and coupled via an inductor. Implemented path cleanups. Made all RF impedence matched.

removed ldo and level shifter replaced the 3v ldo with a switching regulator, replaced level shifter with resistor dividers.

updated thermal pads updated thermal pads

added thermal pads added thermal pads and vias below the lm3480 to prevent biasing the temp sensor

Removed Pours removed pours from under the lm3480 to limit heat reaching the bme280

Moved BME280 moved the bme 280 sensor away from the 3v regulator to help mitigate thermal issues.

Silkscreen cleanup and additional analog pin removed as many silkscreen keep out errors as possible. Added a breakout for analog pin A1 to the bottom header.

moved bme280 decoupling cap moved the bme280 decoupling cap a bit for aesthetic reasons.

Swapped Serial1 RX and TX Fixed an issue sending / receiving serial between the atmega32u4 and ublox max m8q by swapping the rx and tx pins on the atmega32u4.

Added Pull down to HWB pin added a 10k pull down resistor to HWB to resolve issues flashing the boot loader