Updated schematic, board, Gerbers, and BOM to use Seeed Studio PCBA parts where possible Updated CAM job to not silk t/bValue layers Shifted a drill hole just a little

Added signature

Updated silkscreen Added 0 ohm to display connector for theoretical resistive compatibility Updated bom.ods

Tweaked bypass capacitor values (C7, C10, C15) Removed unnecessary HP Sense resistor (R13) Removed pulldown resistor before amp (R12)

Switched shoulder button footprint to one I can buy on digikey

Fixed drill sizes Smoothed out top edge

Cleaned up the silkscreen

Swapped VCC & GND for the volume dial

Fixed TSSOP-8 package

Replaced 0805s with 0603s Fattened power traces